JVC KY-F70BU Instruction Manual - Page 22
Connecting power
View all JVC KY-F70BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
2. Before recording (continued) Connecting power Between the 8 pin DC IN terminal on the rear of the main unit and the 8 pin TO CAMERA terminal of the AC adapter (AA-P700) connect the power cable (2m) which is provided. AA-P700 DC 12V=OUTPUT VIDEO OUTPUT SCSI REC SEND AW/SEL MODE MENU UP DOWN SET PLAY FREEZE MONITOR LENS S(Y/C) OUTPUT TO CAMERA EITHER OUTPUT MAX 1.25A AC adapter SEE INSTRUCTION MANUAL REMOTE ON 1 2 3 4 DC IN POWER SEE INSTRUCTION MANUAL AC White marking Connect the end with the white marking to the AC adapter. Provided power cable Provided Clamp filter CAUTION • Be sure to use the AA-P700 power supply. • Before connecting power cable, make sure that the power switch on the AA-P700 is set to OFF. Connecting with the power switch on may result in camera malfunction. MEMO • Wait at least 10 seconds before turning the power switch back on, when it has just been turned off. • Turning the power switch on and off quickly may cause malfunctions, such as failure to boot, etc. Figure 1 Plug Figure 2 DC IN POWER Ring DC IN POWER Figure 3 E18 DC IN POWER Ⅵ After inserting the plug completely, tighten the securing ring. (Figure 1) Make sure white indication of power cable comes to AA-P700 side. Ⅵ To minimise emission of unwanted electrical waves, mount certainly the provided clamp filter as shown in Figure 2 and 3 on the left. Wind the power cable once around the clamp filter. Ⅵ Ensure that the clamp filter is mounted as close to the camera as possible as shown in the diagram.