JVC UX-EP25 Instruction Manual - Page 30
Troubleshooting, To remove the speaker grilles, Radio Operations
View all JVC UX-EP25 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
To remove the speaker grilles Troubleshooting If you are having a problem with your System, check this list for a possible solution before calling for service. General: Adjustments or settings are suddenly canceled before you finish. @There is a time limit. Repeat the procedure again. Operations are disabled. @The built-in microprocessor may malfunction due to external electrical interference. Unplug the AC power cord and then plug it back in. Unable to operate the System from the remote control. @The path between the remote control and the remote sensor on the System is blocked. @Point it at the remote sensor on the font panel. @Signals cannot reach the remote sensor. More closer to the System. @The batteries are exhausted. No sound is heard from the speakers. @Speaker connections are incorrect or loose (see page 7). @Headphones are connected (see page 9). Sound from PC connected with a USB cable has some noise. (See page 15) @PC is subjected to excessive load due to using other applications. Close the applications you do not use. @PC is connected via USB Hub. Connect the PC directly to the main unit with a USB cable. Radio Operations: Hard to listen to broadcasts because of noise (see pages 4 to 7). @Antennas connections are incorrect or loose. @The AM loop antenna is too close to the System. @The FM antenna is not properly extended and positioned. Disc/iPod/USB mass storage class device Operations: The disc does not play. @The disc is placed upside down. Place the disc with the label side up. MP3/WMA tracks do not play. @Track names have the initial letter ".". The disc sound is discontinuous. @The disc is scratched or dirty. The disc cover does not open or close. @The AC power cord is not plugged in. The iPod doesn't playback although the display indicates CONNECT. @The battery is empty. Let stand for more than approximately ten minutes on the connecting condition. Timer Operations: Daily Timer does not work. @The System has been turned on when the on- time comes. Timer starts working only when the System is turned off. @There might have been a power failure. Set the clock first, then the timer again. 26