JVC UX-EP25 Instruction Manual - Page 6
Introduction, Precautions - micro component system manual
View all JVC UX-EP25 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Introduction Thank you for purchasing the JVC Micro Component System. We hope it will be a valued addition to your home, giving you years of enjoyment. Be sure to read this instruction manual carefully before operating your new stereo system. In it you will find all the information you need to set up and use the system. If you have a query that is not answered by the manual, please contact your dealer. Precautions Installation • Install in a place which is level, dry and neither too hot nor too cold-between 5°C and 35°C (41°F and 95°F). • Install the System in a location with adequate ventilation to prevent internal heat buildup inside the System. Internal heat • A cooling fan is mounted on the right side of the unit to prevent heat buildup inside the main unit (see page G-2). For safety, observe the following carefully: • Make sure there is good ventilation the main unit. Poor ventilation could overheat and damage the System. • DO NOT block the cooling fan and the ventilation openings or holes. If they are blocked by a newspaper or cloth, etc., the heat may not be able to get out. DO NOT install the System in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration. • Leave sufficient distance between the System and the TV. • Keep the speakers away from the TV to avoid interference with TV. Power sources • When unplugging the System from the wall outlet, always pull on the plug, not the AC power cord. DO NOT handle the AC power cord with wet hands. Moisture condensation Moisture may condense on the lenses inside the System in the following cases: • After starting to heat the room • In a damp room • If the System is brought directly from a cold to a warm place Should this occur, the System may malfunction. In this case, leave the System turned on for a few hours until the moisture evaporates, unplug the AC power cord, then plug it in again. 2