JVC V25U Startup Guide - Page 10

Getting Started Side / Rear JK MONITOR OUT PAL OFF NTSC RESET STATUS IRIS ML J [MONITOR OUT] Monitor Output Selection Switch Use this switch to select the availability of output from the N [MONITOR OUT] terminal as well as the signal system. NTSC : Outputs NTSC signals. OFF : No output. Select this value when distributing images to the network. PAL : Outputs PAL signals. [Default setting: OFF] Caution: ● Images are not distributed to the network when ANTSCB or APALB is selected. ● When the switch is changed, press the K Reset button to reboot the unit. K [RESET] Reset Button This is a button for rebooting the camera. Press this button and release within 5 seconds to reboot the camera. It takes about one minute for the camera to reboot. During startup, the [RESET] button is disabled. Note: Pressing the [RESET] button for 5 seconds or longer switches the camera to the service verification mode. Do not press the button for 5 seconds or longer. L [IRIS] Iris Terminal Use this terminal to connect the DC iris lens. (Connection with the video iris lens is not possible.) (A Page 13) M [STATUS] Status Indicator This status of this product is indicated in green or orange color. Starting up: Lights up in orange Startup complete: Lights up in green Error: Blinking (orange or green) 10 Q 1 2 P G2 12 1 OUTPUT INPUT CLASS 2 ONLY FOR USA ISOLATED POWER ONLY FOR EUROPE AND OTHER AC24V ALARM PoE MONITOR OUT 10BASE-T/ SEE INSTRUCTION MANUAL 100BASE-TX CAUTION: NEVER USE PoE AND AC 24V AT THE SAME TIME DO NOT CONNECT TO THE TELEPHONE NETWORK PUSH R NO Note: You can adjust the [LED State] settings via the network to turn off the indicator after startup is complete. N [MONITOR OUT] Monitor Video Signal Output Terminal (RCA) This is an output terminal for composite video signals (1 V (p-p), output impedance of 75 K). Use this terminal to connect to devices such as a video monitor. This terminal is used for adjusting the camera angle during installation. (A Page 16) Note: ● Use the J [MONITOR OUT] switch to select the availability of output as well as the signal system. When the switch is changed, press the K Reset button to reboot the unit. ● When using the [MONITOR OUT] output, set the privacy mask to AOffB. O [10BASE-T/100BASE-TX] Use this terminal to connect to the network via a LAN cable. This product supports PoE (IEEE802.3af class 2) and therefore can be used without a power cable. (A Page 14)(A Page 16) P [ALARM INPUT/OUTPUT] Alarm Input/ Output Terminals Use these terminals to connect to an external alarm device. (A Page 17) Q [AC24V] Power Input Terminal Use this terminal to connect to an AC 24 V, 50/60 Hz power supply. (A Page 15) R Fall Prevention Wire Mounting Screw (M3 x 6 mm) Use this screw to mount the fall prevention wire. (A Page 18)