Jenn-Air JGRP548HL Installation Instructions - Page 17
To Convert Gas Pressure Regulator from Natural Gas, to Propane, Propane Gas, Gas Supply Pressure
View all Jenn-Air JGRP548HL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
To Convert Gas Pressure Regulator from Natural Gas to Propane NOTE: Door must be removed in order to remove or replace kick plate. Refer to the "Remove Door" section. 1. Lift the kick plate up and off of the kick plate tab. 5. Turn over the gas pressure regulator cap, and reinstall on the regulator so that the hollow end faces out and the letters "LP" are visible. A B C A. Kick plate B. Kick plate tab C. Kick plate slot 2. Gently lay kick plate aside to avoid scratching. 3. Locate the gas pressure regulator at the left rear of the range. A A. Gas pressure regulator 4. Remove the gas pressure regulator cap by using a large flat-blade screwdriver, turning the regulator cap counterclockwise. NOTE: Do not remove the spring beneath the cap. 6. Tighten the gas pressure regulator cap by using a large flat-blade screwdriver, turning the regulator cap clockwise. 7. Test the gas pressure regulator and gas supply line. The regulator must be checked at a minimum 1" (2.5 cm) water column above the set pressure. The inlet pressure to the regulator should be as follows for operation and checking the regulator setting: Propane Gas: Minimum pressure: 11" (27.9 cm) WCP Maximum pressure: 14" (35.6 cm) WCP Gas Supply Pressure Testing Gas supply pressure for testing regulator must be at least 1" (2.5 cm) water column pressure above the manifold pressure shown on the model/serial/rating plate. Line pressure testing above 1/2 psi (3.5 kPa) gauge (14" [35.6 cm] WCP) The range and its individual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.5 kPa). Line pressure testing at 1/2 psi (3.5 kPa) gauge (14" [35.6 cm] WCP) or lower The range must be isolated from the gas supply piping system by closing its individual manual shut-off valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa). 17