Jenn-Air JGRP548HL Installation Instructions - Page 23

Replace Oven Bake Burner Cover 1. Align notches on the oven bake burner cover with shoulder screws in the bottom of the oven. 2. Pull the broil burner toward you until it slides out of the hole in the oven back, and pull the electrode out of the bracket. The broil burner will hang down in the back of the oven while you change the orifice. A A A B B A. Cover notches (4) B. Shoulder screws (4) 2. Lower cover, and slide to left or right to slide shoulder screws into the narrow ends of the notches, then lock into place. B A. Grasp electrode here. B. Bracket Broil burner hanging in back of oven 3. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Insert nut driver into the gas opening, and press down onto the gas orifice spud, then remove by turning the gas orifice spud counterclockwise and lifting out. Set gas orifice spud aside. A A. Bake burner cover Convert Oven Broil Burner (30" [76.2 cm] and 36" [91.4 cm] models and the right oven cavity on 48" [121.9 cm] models) 1. Using a 1/4" (6.4 mm) nut driver, remove broil burner screw. Set aside with side igniter positioned on the right. A A BC A. Oven back B. Broil burner orifice C. Broil burner orifice hole 4. Gas orifice studs are stamped with a letter and a number. Install the Number 90 oven broil burner orifice spud. 5. Place Natural gas orifice in plastic parts bag for future use, and keep with package containing literature. 6. Replace the broil burner in the hole in the oven back with the broil burner assembly inside the broil burner electrode hole as illustrated. B C A. Broil burner screw B. Broil burner C. Broil burner orifice hole A A. Broil burner orifice hole B. Broil burner electrode C. Broil burner electrode hole BC 7. Reinstall the oven broil burner screw. See Step 1 for illustration. The screw is aligned with the hole when a click sounds. 23