Jenn-Air JGRP548HL Installation Instructions - Page 33

2. Pull the broil burner toward you until it slides out of the hole in the oven back, and pull the electrode out of the bracket. The broil burner will hang down in the back of the oven while you change the orifice. A Convert Oven Bake Burner (left oven cavity on 48" [121.9 cm] models) 1. Remove oven racks. See the "Remove Racks" section. 2. Remove the oven door. See the "Remove Oven Door" section. 3. Slide the bake burner cover to the right or left. B A. Grasp electrode here. B. Bracket Broil burner hanging in back of oven 3. Apply masking tape to the end of a 1/4" (6.4 mm) nut driver to help hold the gas orifice spud in the nut driver while changing it. Insert nut driver into the gas opening, and press down onto the gas orifice spud, then remove by turning the gas orifice spud counterclockwise and lifting out. Set gas orifice spud aside. A A. Bake burner cover 4. Lift up and remove oven bake burner cover, and set aside. 5. Remove the oven bake burner screws and oven bake burner, and gently set aside. A D A BC A A. Oven back C B B. Broil burner orifice C. Broil burner orifice hole 4. Gas orifice studs are stamped with a letter and a number. Install the Number 148 oven broil burner orifice spud. 5. Place Propane gas orifice in plastic parts bag for future use, and keep with package containing literature. 6. Replace the broil burner in the hole in the oven back with the broil burner assembly inside the broil burner electrode hole as illustrated. A. Oven bake burner B. Oven bake burner screws C. Oven bake burner electrode bracket D. Oven bake burner electrode A A. Broil burner orifice hole B. Broil burner electrode C. Broil burner electrode hole BC 7. Reinstall the oven broil burner screw. See Step 1 for illustration. The screw is aligned with the hole when a click sounds. 33