Jenn-Air JGRP548HL Installation Instructions - Page 5
Adjusting Simmer Low and Main Low Settings, on Surface Burner for Propane, on Surface Burner
View all Jenn-Air JGRP548HL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Parts Supplied Check that all parts are included. ■ Anti-tip bracket kit � A B A. Anti-tip bracket B. #8-18 x 1" (2.5 cm) Phillips head screws (4) NOTE: Anti-tip bracket must be securely mounted to subfloor. Thickness of flooring may require longer screws to anchor bracket to subfloor. Longer screws are available from your local hardware store. See the "Install Anti-Tip Bracket" section. ■ Burner grates ■ Burner caps ■ Griddle drip tray (on griddle models) Parts Needed ■ All models must be installed with a backguard if installing at zero clearance to a combustible back wall surface such as drywall. Alternatively, zero clearance to a back wall is acceptable provided the surface of the entire back wall above the range and below the hood is covered with a non-combustible material such as tile or stainless steel. See "Cabinet Dimensions" in the "Location Requirements" section for installation requirements. Check local codes and consult gas supplier. Check existing gas supply and electrical supply. See the "Electrical Requirements" and "Gas Supply Requirements" sections. It is recommended that all electrical connections be made by a licensed, qualified electrical installer. High Altitude Conversion Reorificing of this range/rangetop is not required for proper operation. Low burner rates may require resetting for best results. Refer to the "Adjusting Simmer Low and Main Low Settings on Surface Burner for Propane" section (page 18) for Propane Gas Operation. Refer to the "Adjusting Simmer Low and Main Low Settings on Surface Burner for Natural Gas" section (page 28) for Natural Gas Operation. 5