Kenmore 3314 Owners Manual - Page 22

Ifthewaterheater

Get Kenmore 3314 - Power Miser 12 PDF manuals and user guides View all Kenmore 3314 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

2. CLOSEthecoldwateirnlevt alvetothewatehr eater. 3. OPENanearbhyotwatefrauceatndleaveopentoallowfor draining. 4. Connecat hoseto thedrainvalveandterminatteo an adequatderain. 5. OPENthewatehr eatedrrainvalvetoallowfortankdraining. 5. Screw the handle and cap assembly back into the drain valve and retighten using a wrench. DO NOT OVER TIGHTEN. 6. Follow instructions in the FiihtTg The Water Heater section. 7. Check for leaks. 8. Follow the lighting instructions restart the water heater. in the Lighting section to NOTEI:f thewaterheateirsgoingto beshutdownand drainedforanextendepderiodt,hedrainvalveshouldbe leftopenwithhoseconnecteadllowingwatetroterminate to anadequatderain. 6. Closethedrainvalve. _HANDLEAND CAP ASSEMBLY % WASHER 7. FollowinstructioninstheFilling The Water heater section. 8. Follow the lighting instructions restart the water heater. in the Lighting section to Drain Valve Washer Repmacement (See Figure 25) 1. Turn "OFF" gas supply to water heater. 2. Follow "Draining" instructions. 3. Turning counter clockwise ( _ ), remove the hex cap below the screw handle. 4. Remove the washer and put the new one in place. Service FIGURE 25. Before calling for repair service, read the Start Up Conditions and Operational Conditions found in the Troubleshooting Guide of this manual. If a condition persists or you are uncertain about the operation of the water heater, let the Sears Service Center check it out. Contact Sears Service Center at: 1-800o4-MyoHOME _'_(1o800o469o4663), 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
2. CLOSE
thecoldwater
inlet
valve
tothewater
heater.
3.OPENanearby
hotwater
faucet
and
leaveopen
toallow
for
draining.
4. Connect
ahosetothedrainvalveandterminate
to an
adequate
drain.
5. OPEN
thewater
heater
drainvalve
toallow
fortankdraining.
NOTE:
Ifthewaterheater
isgoingtobeshutdownand
drained
foranextended
period,
thedrainvalveshouldbe
leftopenwithhoseconnected
allowingwater
toterminate
toanadequate
drain.
6. Close
thedrainvalve.
7. Follow
instructions
inthe
Filling
The
Water
heater
section.
8.
Follow
the
lighting
instructions
in
the
Lighting
section
to
restart
the
water
heater.
Drain
Valve
Washer
Repmacement
(See
Figure
25)
1.
Turn
"OFF"
gas
supply
to
water
heater.
2.
Follow
"Draining"
instructions.
3.
Turning
counter
clockwise
(_
), remove
the
hex
cap
below
the
screw
handle.
4.
Remove
the
washer
and
put
the
new
one
in place.
5.
Screw
the
handle
and
cap
assembly
back
into
the
drain
valve
and
retighten
using
a
wrench.
DO
NOT
OVER
TIGHTEN.
6.
Follow
instructions
in the
FiihtTg
The
Water
Heater
section.
7.
Check
for
leaks.
8.
Follow
the
lighting
instructions
in the
Lighting
section
to
restart
the
water
heater.
_HANDLEAND
CAP
ASSEMBLY
%
WASHER
FIGURE
25.
Service
Before
calling
for
repair
service,
read
the
Start
Up
Conditions
and
Operational
Conditions
found
in the
Troubleshooting
Guide
of this
manual.
If a condition
persists
or you
are
uncertain
about
the
operation
of the
water
heater,
let the
Sears
Service
Center
check
it out.
Contact
Sears
Service
Center
at:
1-800o4-MyoHOME
_'_(1o800o469o4663),
22