Kenmore 3693 Owners Manual - Page 17

,WARNING Electrical Shock And Personal Injury Hazard Unplug power cord from electrical outlet. Do not operate the vacuum cleaner without the primary or exhaust filters. Be sure the filters are properly installed to prevent motor failure and or electrical shock. PRIMARY FILTER Check primary filter frequently when dirty. and clean TO REMOVE PRIMARY FILTER Remove the dust bin assernbly as outlined in the DUST BIN CLEANING section. Make sure dust bin is free of debris before removing lid and filter. Rotate dust bin lid assembly counterclockwise as indicated on the lid and lift off. Turn This Direction To Open For Emptying Closed (For Use) Remove primary filter by turning it counterclock- wise and pulling out (See arrows on bottom of fil- ter). Rinse with water only as needed, do not use any detergent or soap. Dust Bin Lid Allow the filter to dry for 24 hours before putting it back into the vacuum. When cleaning the filter no longer restores vacuum suction to full power you need to replace the filter. Note: See PARTS AND FEATURES for the filter number. TO REPLACE PRIMARY FILTER To replace filter, insert it over cleaning cams as far as it will go. Make sure rubber seal at top of filter is flush against filter supporter, then turn filter clockwise to secure into place. Note: Under normal use and care, your filter can be expected to last up to 5 years. Cams Rubber Open (For Emptying) While holding dust bin lid over a trash container grasp primary filter, rotate counterclockwise and lift off. Clean primary filter by gently tapping over a trash container. Tap on several sides to ensure best cleaning. Supporter Dust Bin Lid Re-assemble dust bin lid to dust bin. see To REPLACE DUST BIN LID. 17