Kenmore 63263 Use and Care Guide - Page 20
Questions, and Answers
UPC - 719192632639
View all Kenmore 63263 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Questions and Answers Operation Question Why is the oven light not on during cooking? Why does steam come out of the air exhaust vent? Answer There may be several Have you: • Set a cooking time? • Touched START? reasons why the oven light is not on. Steam is normally produced during cooking. The microwave oven has been designed to vent this steam. Will the microwave oven be damaged if it operates empty? Yes. Never operate the oven empty or without the glass turntable. Does microwave energy pass through the viewing screen in the door? No. The metal screen bounces the energy back to the oven cavity. The holes (or ports) allow only light to pass through. They do not let microwave energy pass through. Why does a tone sound when a pad on the control panel is touched? The tone tells you that the setting has been entered. Can my microwave oven be damaged if food is cooked for too long? Like any other cooking appliance, it is possible to overcook food to the point that the food creates smoke and even possibly fire, and damage to the inside of the oven. It is always best to be near the oven while you are cooking. When the oven is plugged into wall outlet for the first time, it does not work properly, What is wrong? The microcomputer controlling your oven may temporarily become scrambled and fail to function as programmed when you plug in for the first time or when power resumes after a power interruption. Unplug the oven from the 120 volt household outlet and then plug it back in to reset the microcomputer. Why do I see light reflection around the outer case? What are the various sounds I hear when the microwave oven is operating? This light is from the oven light which is located between the oven cavity and the outer wall of the oven. The clicking sound is caused by a mechanical switch turning the microwave oven's magnetron ON and OFR The heavy hum and clunk is from the change in power the magnetron draws as it is turned ON and OFF by a mechanical switch.The change in blower speed is from the change in line voltage caused by the magnetron being turned ON and OFR 2O