Kenmore 7531 Use and Care Guide - Page 8

ExcessiveWeightHazard Usetwoor morepeopleto moveandinstall refrigerator. Failureto dosocanresultin backor otherinjury. UNPACKING YOUR REFRIGERATOR Remove tape and any temporary labels from your refrigerator before using. Do not remove any warning-type labels or the model and serial number label. To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see the important Safety instructions section. Refrigerator shelves are installed in the shipping position. Please reinstall shelves according to your individual storage needs. When Moving Your Refrigerator: Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. Do not wiggle or walk the refrigerator when trying to move it, as floor damage could occur. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from refrigerator. Failure to do so can result in death, explosion or fire. INSTALLATION 1. Avoid placing unit near heat sources, direct sunlight or moisture. 2. To minimize noise and vibration, the refrigerator MUST be installed on a solidly constructed floor. 3. Carpeting and soft tile surfaces are not recommended. 4. NEVER install the refrigerator on a platform or a weakly supported structure. 5. Install this appliance in an area where the temperature is between 55°F (13°C) and 110°F (43°C.) If the temperature around the appliance is too low or high, cooling ability may be adversely affected. 8 NOTE: For proper air circulation, best cooling and energy consumption results, maintain a minimum distance of 2 inches (5.08cm) from adjacent items and surfaces. 2" (5.08 cm)_'_ (5.08 cm) 2"--_, 2" (5.08 cm) (5.08 cm) • Be careful when you work with hinge, base grille, stopper etc. You may be injured. • Do not put hands or metal sticks into air vents, base grille or bottom of refrigerator. You may be injured or receive an electrical shock. BASE GRILLE INSTRUCTIONS To install Base Grille • Refrigerator door should be opened or removed. • Use the 2 Phillips screws provided in the literature package to attach the Base Grille. To Remove Grille . Open or remove refrigerator door. " Take out the base grille by removing the 2 screws on the bottom of the refrigerator.