Kenmore 7755 Use and Care Guide - Page 16

Setting Oven Controls • Continuous Bake or Twelve Hour Energy Saving Mode • Timer Setting Continuous Bake or 12 Hour Energy Saving The TIMER _si_m0ea_nd FLEX CLEAN _, pads control the Continuous Bake or 12 Hour Energy Saving features. The oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven control is left on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for Continuous Baking. INSTRUCTIONS PRESS DISPLAY To set the control for Continuous Energy Saving features: Bake or 12 Hour 1. Press and hold @ for 6 seconds or until the control beeps once. (Fig.l). "12h" or "- - h" will appear in the display and the control will beep once. for 6 seconds Fig. 1 2. Press _cc_n_ to switch between the 12 Hour Energy Saving and v continuous bake features. Note: "12h" (See Fig. 2) in the display indicates the control is set for 12 Hour Energy Saving feature and "- - h" (See Fig. 3) indicates the control is set for the Continuous Bake feature. 3. Press @ to accept the change (See Fig. 4) display will _or @ Fig. 2 Fig.3 return to time of day or press _ to reject the change. Setting Timer Fig. 4 The TIMER _o_ pad controls the Timer feature. The Timer serves as an extra reminder in the kitchen that will beep when the set time has run out. The Timer will not START or STOP the cooking process. The Timer feature may be used during any of the other oven control functions. Refer to "Minumum & Maximum Control Pad Settings" section for time amount settings. INSTRUCTIONS PRESS DISPLAY To set the Timer (example for 5 minutes): 1. Press _ o(See Fig. 5). 2. Press the number pads to set the desired time in the display (example (Sj_). Press @.The down. (See Fig. 6). timer will begins count Note: If @ is not pressed the timer will return to the time of day. 3. When the set time has run out, the clock will sound with 3 long beeps every 5 seconds until d_t_0e5is pressed (See Fig. 7). Fig. 5 Fig. 6 To cancel the Timer before the set time has run out: Press _r_. The display will return to the time of day. Fig. 7 16