Kenmore 7755 Use and Care Guide - Page 5
Before, Using, Range
View all Kenmore 7755 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
important Safety instructions GROUNDING iNSTRUCTiONS See the INSTALLATION INSTRUCTIONS packaged with this range for complete installation and grounding instructions. For personal safety, the range must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correctly polarized and properly grounded. Important Safety Notice The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the state to cause cancer, birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure to such substances. Before Using Your Range Assembly of Burner Heads & Burner Caps Your range is shipped with the Burner Heads and Burner Caps in the correct locations, Packing material may be located between the Burner Heads and the cooktop. The following instructions apply to all burners except the right front double burner. For assembly instructions for the double burner see the General Care & Cleaning section. All other models a. Be sure to follow the installation instructions before installing and using your new range. b. Remove all packing tape from cooktop area. Remove all Burner Caps and Burner Heads. c. Discard all packing material located under Burner Heads. Please note: Models with a right front double ring burner are not marked with letters d. To replace Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside Burner Heads (Figs. 1 & 2). e. Match the letters stamped on Burner Skirts with Burner Heads and Burner Caps (See Fig. 1). Replace the Burner Heads and Caps on cooktop (See Fig. 2). Carefully align the Electrodes into slot of each Burner Head (Fig. 3).The Burner Heads should sit flat on Cooktop Burner Skirts.. f. Unpack Burner Grates and position on the cooktop. Burner "::_'P 2)_!'_!;_\ Head / _b_f j_:/iJj : L::::: ii.i........... ...i.i..i Fig. 1 ode _ Fig. 3 FigE.le2ctrodes must lign into slot for each Burner Head Conversion to Liquefied Petroleum Gas (or L.P. Gas) The natural gas range is designed to allow for conversion to Liquefied Petroleum (L.P.) Gas. Please note: Models equipped with a double right front gas burner are not L.P. Convertible. If L.P. conversion is needed, contact your local L.P. gas provider for assistance. The L.P. Conversion Kit is provided with this range and is located on the left lower REAR (back side) panel of the range. Before installing the kit be sure to follow the L.P. Installation Instructions carefully. Personal injury or death from electrical shock may occur if the range is not installed by a qualified installer or electrician. Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by Sears Service.