Kenmore 9961 Use and Care Guide - Page 41

General Cleaning & Maintenance Pull up with finger Storage Drawer Use the storage drawer for storing cooking utensils. The drawer can be removed to facilitate cleaning under the range. Use care when handling the drawer. To Remove Storage Drawer: 1. Open the drawer to the fully opened position. 2. Locate the glide lever on each side of drawer; pull up on the left glide lever and push down on the right glide lever (see figure 1). 3. Pull the drawer away from the range. Push down with finger Figure 1 Glide To Replace Storage Drawer: 1. Pull the bearing glides to the front of the range (see figure 2). 2. Align the drawer glides with the slots on the bearing glides. 3. Push the drawer into the range until the glides levers "click" (approx. 2 in.). Pull the drawer open again to seat it into position. 4. If you do not hear the glide levers "click" or if the drawer does not feel seated, remove it and repeat steps 1 through 3. Doing so will minimize damage to the bearing glides. Do not try to force the drawer into place. Figure 2 Storage Drawer Flammable materials should not be stored in an oven, near surface elements or in the storage drawer or compartment (if equipped). This includes paper, m plastic and cloth items, such as cookbooks, plasticware and towels, as well as flammable _:_ liquids. Do not store explosives, such as aerosol cans, on or near the range. Flammable materials may explode and result in fire or property damage. _o Lock in normal position To Remove and Replace Right Oven Door O) 1. Open the door to the fully opened position. 2. Pull up the lock located on both hinge supports and engage it in the hinge levers.You may have to apply a little downward pressure on the door to pull the locks fully over the hooks. 3. Grab the door by the sides, pull the bottom of the door up and toward you to disen- gage the hinge supports. Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disengage the hinge levers from the hinge slots. 4. To replace the door, reverse the door removal steps. Make sure the hinge supports are fully engaged before unlocking the hinge levers. The door is heavy. After removing door, lay it flat on the floor with its inside facing down. k engaged for door removal slot To Change the Oven Light The oven light automaticallyturns on when the door isopened (some models). To turn the oven light on and off when the door is closed, usa the OVEN LIGHT switch located on the control panel. 1. Turnelectricalpoweroffatthemainsourcaorunplugtha oven. 2. Wear a leather-faced glove for protection against possible broken glass. 3. Press wire holder to one side to release the glass shield. 4. Replace bulb with a new 40 watt appliance bulb. 5. Replace glass shield in socket and snap wire holder into place. 6. Turn power back on at the main source (or plug the appliance back in). 7. The clockwill then need to be reset. To reset, see Setting the Clockand Minute Timer in the ELECTRONIC OVEN CONTROL manual. Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life. 41