Kenwood 6020 Instruction Manual - Page 25
Compression Control Level Adjustment, Position Setting, Room Size Setting
View all Kenwood 6020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Compression Control Level Adjustment This function can compress the dynamic range of music, so that low sounds which are covered over by road noise can be raised. 4 Press the DSP button to end the DSP control mode. 1 Press the DSP button. "DSP CTRL" is displayed once the DSP control mode is entered. The DSP indicator blinks during the DSP control mode. 2 Each time you press the COMP button, the compression level switches as follows; ➨ "Comp Off" ➨ "Comp STEP 1" (Compression level is lower) ➨ "Comp STEP 2" ➨ "Comp STEP 3" (Compression level is higher) ➨ NOTE The default setting is "Off". 3 Press the DSP button to end the DSP control mode. Room Size Setting This function can set the DSP effects for various room sizes. 1 Press the DSP button. "DSP CTRL" is displayed once the DSP control mode is entered. The DSP indicator blinks during the DSP control mode. 2 Press the R.SIZE button. The position currently set appears in the display. 3 Each time you press the 4 or ¢ button, the room size switches as follows; "Room Large" (For large vans or RVs, etc.) j "Room Medium"(For sedans, etc.) j "Room Small" (For compact cars, etc.) Position Setting This function can set the DSP effects for various listening positions. 1 Press the DSP button. "DSP CTRL" is displayed once the DSP control mode is entered. The DSP indicator blinks during the DSP control mode. 2 Press the POSI button. The position currently set appears in the display. 3 Each time you press the POSI button, the position switches as follows; ➨ "ALL" ➨ "Front-Right" ➨ "Front-Left" ➨ "Front" ➨ "Rear" ➨ NOTE • This adjustment cannot be made when the Position Setting is set to "ALL". • The default setting is "Medium". 4 Press the DSP button to end the DSP control mode. NOTE • Be sure to set the balance and fader control to center position. If their settings are not set to center position, the Position Setting effect will not be obtained properly. • The default setting is "ALL". - 25 -