Kenwood 6020 Instruction Manual - Page 8
Sliding the panel, Switching the Display During the Standby Mode, Panel Angle Adjustment
View all Kenwood 6020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English General features Panel Angle Adjustment You can adjust the panel angle for easy viewing. Sliding the panel: Press the ANGLE∞ button. Each time you press the ANGLE∞ button, the panel will slide one step at a time.The faceplate angle can be varied in up to ten steps. NOTE If the power is turned off, the panel will close automatically. When you turn the power back on, the panel angle will return to the adjusted angle position. Closing the panel: Press the 5ANGLE RTN button to close the panel. NOTE The sound will be muted while the panel is sliding during the tape mode. 2CAUTION • Take care that your fingers and so on do not get caught during the slide operation of the front panel. • When the front panel has been slid, it might interfere with the shift lever or something else. If this happens, pay attention to safety and move the shift lever or take an appropriate action, then operate the unit. • Do not apply excessive force to the front panel after it slides. Switching Display You can switch the display during the standby mode as mentioned below. Switching the Display During the Standby Mode: Each time you press the DISP button during the standby mode, the display switches as follows: Character with graphic display Clock with graphic display Clock -8-