Kenwood DDX1035 Operation Manual - Page 35

CAUTION, the brake lamps, blinkers, wipers, etc.

Get Kenwood DDX1035 PDF manuals and user guides View all Kenwood DDX1035 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

• Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the · wires or ground them to any metal part in the car. • When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not use one from each). For example, if you connect the ª connector of the left speaker to a front output terminal, do not connect the · connector to a rear output terminal. • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. • Mount the unit so that the mounting angle is 30° or less. • Do not press hard on the panel surface when installing the unit to the vehicle. Otherwise scars, damage, or failure may result. ¤ CAUTION Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot. English 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
English
35
• Connect the speaker wires correctly to the
terminals to which they correspond. The
unit may be damaged or fail to work if you
share the
·
wires or ground them to any
metal part in the car.
• When only two speakers are being
connected to the system, connect the
connectors either to both the front output
terminals or to both the rear output
terminals (do not use one from each). For
example, if you connect the
ª
connector
of the left speaker to a front output
terminal, do not connect the
·
connector
to a rear output terminal.
• After the unit is installed, check whether
the brake lamps, blinkers, wipers, etc. on
the car are working properly.
• Mount the unit so that the mounting angle
is 30° or less.
• Do not press hard on the panel surface
when installing the unit to the vehicle.
Otherwise scars, damage, or failure may
result.
¤
CAUTION
Install this unit in the console of your
vehicle.
Do not touch the metal part of this unit
during and shortly after the use of the
unit. Metal part such as the heat sink and
enclosure become hot.