Kenwood DDX7025BT Operation Manual - Page 54
Installing the unit
View all Kenwood DDX7025BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
CONNECTION/INSTALLATION ❏ Supplied accessories for installation 1 Wiring harness x 1 2 Trim plate x 1 3 Extension wire x 1 4 Extraction keys x 2 5 Microphone x 1 6 Fixture for HDMI/MHL connector x 1 7 Screws for fixture (M2.6 x 6 mm) x 1 ❏ Installation procedure 1 To prevent a short circuit, remove the key from the ignition and disconnect the · battery. 2 Make the proper input and output wire connections for each unit. 3 Connect the speaker wires of the wiring harness. 4 Take Connector B on the wiring harness and connect it to the speaker connector in your vehicle. 5 Take Connector A on the wiring harness and connect it to the external power connector in your vehicle. 6 Connect the wiring harness connector to the unit. 7 Install the unit in your car. • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). 8 Reconnect the · battery. 9 Press the reset button. 10 Configure . (Page 4) Installing the unit ❏ Installing the unit • Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. ❏ Installing the trim plate Attach the trim plate (2). 2 54