Kenwood DDX9902S Operation Manual - Page 67
Connection
View all Kenwood DDX9902S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
CONNECTION/INSTALLATION Connection R Connecting wires to terminals USB input terminal (1.0 m): Pages 67 - 68 Pages 67 - 69 GPS antenna terminal: Page 70 Connect the antenna cord to the antenna terminal. Pages 67 - 69 Page 69 Purple with white stripe (Reverse sensor wire) Connect to the vehicle's reverse lamp harness when using the optional rear view camera. Light green (Parking sensor wire) 3 10 A fuse Connect SiriusXM Connect Vehicle Tuner (commercially available). See page 69. Connect to the vehicle's parking brake detection switch harness. • For best safety, be sure to connect the parking sensor. 1 White ª / White with black stripe · : To front speaker (left) Gray ª / Gray with black stripe · : To front speaker (right) Green ª / Green with black stripe · : To rear speaker (left) Purple ª / Purple with black stripe · : To rear speaker (right) * Blue (Antenna control wire) Blue with white stripe (Power control wire) Brown (Mute control wire) Light blue with yellow stripe (Steering remote control wire) Orange with white stripe (Dimmer control wire) Red (Ignition wire) Yellow (Battery wire) Black (Ground wire) 66 (ACC) (BATT) (GND) * If no connections are made, do not let the cable come out from the tab. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna. (Max. 300 mA, 12 V) When using the optional power amplifier, connect to its power control terminal. Not used. To use the steering wheel remote control feature, an exclusive remote adapter (not supplied) matching your car is required. To car light control switch Ignition key switch To car chassis Fuse box Battery