Kenwood DNN992 Quick Start Guide 1 - Page 19
Installation, Before Installation, WARNINGS, CAUTION, NOTES - wiring
View all Kenwood DNN992 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Call using the phonebook 1) Touch [ ]. 2) Select the name from the list. 3) Select the number from the list. 4) Touch [ ]. Call using the preset number 1) Touch [Preset #] to start calling the corresponding phone number. Call by voice You can make a voice call using the voice recognition function of the cell-phone. 1) Touch [ ]. 2) Pronounce the name registered in the cell- phone. ✎✎NOTE • For detailed operation, see Using Hands-Free Feature (P.120) in the Instruction Manual. Installation ÑÑBefore Installation Before installation of this unit, please note the following precautions. !!WARNINGS • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. • Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). The power supply must be connected to the wires via the fuse. !!CAUTION • Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot. ✎✎NOTES • Mounting and wiring this product requires skills and experience. For best safety, leave the mounting and wiring work to professionals. • Make sure to ground the unit to a negative 12V DC power supply. • Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing. • Do not use your own screws. Use only the screws provided. If you use the wrong screws, you could damage the unit. • If the power is not turned ON ("PROTECT" is displayed), the speaker wire may have a shortcircuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked. • If your car's ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, such as with battery wires, the battery may be drained. • If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening. • If the fuse blows, first make sure the wires aren't touching to cause a short circuit, then replace the old fuse with one with the same rating. English ñ 19