Kenwood DNN992 Quick Start Guide 1 - Page 21
Non-Japanese cars, General Motors cars DNN992, Toyota/Scion cars DNN992, First Step P.7
View all Kenwood DNN992 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
ÑÑUnit 1) To prevent a short circuit, remove the key from the ignition and disconnect the ¤ terminal of the battery. 2) Make the proper input and output wire connections for each unit. 3) Connect the speaker wires of the wiring harness. 4) Connect the wiring harness wires in the following order; ground, battery, ignition. 5) Connect the wiring harness connector to the unit. 6) Install the unit in your car. 7) Reconnect the ¤ terminal of the battery. 8) Press the button. (P.4) 9) Perform the Initial Setup. See First Step (P.7). Non-Japanese cars ÑÑTrim plate 1) Attach accessory 8 to the unit. 8 General Motors cars (DNN992) 1) Cut out accessory 4 to meet the shape of the opening of the center console. 2) Attach accessory 4 to the unit. Cut out to meet the shape of the opening in the vehicle. Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. Japanese cars 6 or 7 Car Bracket 6 or 7 4 Toyota/Scion cars (DNN992) 1) Cut out accessory 4 as illustrated. Cutting line 4 ✎✎NOTE • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). 2) Fold double-sided adhesive (accessory 5) along the slit and attach it to accessory 4 cut-out against the center rib as illustrated. Use 2 pieces of accessory 5 for 1 accessory 4 cut-out. English ñ 21