Kenwood DNN992 Quick Start Guide 1 - Page 22

3) Attach accessory 4 cut-out to the unit. 5 ÑÑGPS antenna GPS antenna is installed inside of the car. It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals. To mount the GPS antenna inside your vehicle: 1) Clean your dashboard or other surface. 2) Remove the separator of the metal plate (accessory 0). 3) Press the metal plate (accessory 0) down firmly on your dashboard or other mounting surface. You can bend the metal plate (accessory 0) to conform to a curved surface, if necessary. 4) Remove the separator of the GPS antenna (accessory 9), and stick the antenna to the metal plate (accessory 0). 9 0 the GPS satellite may be interfered with by these types of communication. • Painting the GPS antenna with (metallic) paint may cause a drop in performance. ÑÑMicrophone unit and Push-To-Talk Switch 1) Check the installation position of the microphone (accessory -) and the Push-To-Talk switch (accessory = : DNN992 only). 2) Clean the installation surface. 3) Install the microphone. 4) Wire the microphone cable up to the unit with it secured at several positions using tape or other desired method. = Fix a cable with a commercial item of tape. = (DNN992 only) Remove the separator of the microphone, and stick the microphone to the place shown above. ✎✎NOTE • Depending on the type of car, reception of the GPS satellite signals might not be possible with an inside installation. • Please install this GPS antenna in an area away from any antennas that are used with CB radios or satellite televisions. • The GPS antenna should be installed at a position that is spaced at least 12 inch (30 cm) from cellular phone or other transmitting antennas. Signals from Adjust the direction of the microphone to the driver. ✎✎NOTE • Install the microphone as far as possible from the cell-phone. 22 ñ English