Kenwood DNN992 Quick Start Guide 1 - Page 9
Touch [Finish]., Touch [Administrator] or [Owner]., OEM SETUP North America Sales area only
View all Kenwood DNN992 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
OEM SETUP (North America Sales area only) This function requires a commercial adaptor. Consult your Kenwood dealer for details. DEMO Set the demonstration mode. Default is "ON". ÑÑHow to prepare the remote control Insert two "AAA"/"R03"-size batteries with the and poles aligned properly, following the illustration inside the case. 5 Touch [Finish]. ✎✎NOTE • For details on operations of each setting, refer to the Instruction Manual. 6 Touch [Administrator] or [Owner]. !!CAUTION • Put the remote controller in a place where it will not move during braking or other operations. A dangerous situation could result, if the remote controller falls down and gets wedged under the pedals while driving. • Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation may result. • Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a physician. • Place the battery out of reach of children. In the unlikely event that a child swallows the battery, immediately consult a physician. English ñ 9