Kenwood DNX4280BT User Manual - Page 80
Car type DTA setup, ON in Speaker Setup.
View all Kenwood DNX4280BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
3 Select a speaker size using [2] and [3]. The speaker size is different depending on the speaker type and the unit. Front OEM, 10 cm, 13 cm, 16 cm, 17 cm, 18 cm, 4x6, 5x7, 6x8, 6x9, 7x10 Rear None, OEM, 10 cm, 13 cm, 16 cm, 17 cm, 18 cm, 4x6, 5x7, 6x8, 6x9, 7x10 Subwoofer None, 16 cm, 20 cm, 25 cm, 30 cm, 38 cm over NOTE • Select "None" if you have no speakers. Front Standard, Wide, Middle, Narrow Crossover network setup You can set a crossover frequency of speakers. 1 Touch the speaker to set the crossover in the Speaker Select screen. 2 Touch [X'over]. X'over screen appears. 3 Set each item as follows. Return to the Top page Audio Setting Up HPF FREQ High Pass Filter adjustment. (When front or rear speaker is selected on Speaker Select screen) LPF FREQ Low Pass Filter adjustment. (When subwoofer is selected on Speaker Select screen) Slope Sets a crossover slope. * T his function is available in the specific situation. Only when "Subwoofer" is set to "ON" in "Speaker Setup". Only when "Subwoofer" is set to "ON" in "Speaker Setup" and "LPF FREQ" is set to other than "Through". Car type (DTA) setup You can setup the car type and speaker network, etc. 1 Touch [Car Type] in the Audio SETUP screen. Car Type screen appears. 2 Select your car type from the list. Phase* Sets the phase of subwoofer output. The phase is reversed 180 degrees when set to "Reverse." NOTE • You may not be able to select your car type from the list. • If your car type is selected, the Delay Time Alignment and Equalizer is set automatically (for timing adjustment of sound output for each channel) to have the highest surround effects. 79