Kenwood DNX6980 dnx7180 (pdf) - Page 88
Zone Control, LEVEL, Q Factor, Bass DC EXT, Flat], Subwoofer Level, Front Source, Rear Source
UPC - 019048192707
View all Kenwood DNX6980 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Controlling equalizer manually 1 Touch [Tone] in the Equalizer screen. 2 Set each item as follows. Return to the Top page Audio Setting Up Zone Control You can select different sources for both front and rear positions in the vehicle. 1 Touch [Zone Control]. FREQ Adjusts the center frequency for each range. Setting values are as follows. Bass: 40Hz/50Hz/60Hz/70Hz/80Hz/100Hz/120 Hz/150Hz (Default is "100Hz.") Middle: 500Hz/1kHz/1.5kHz/2kHz (Default is "1kHz.") Treble: 10kHz/12.5kHz/15kHz/17.5kHz (Default is "12.5kHz.") LEVEL Adjusts the level of each range. Each setting value is within -8dB and 8dB and default is "0dB." Q Factor Adjust Q value for bass and middle. Setting values are as follows. Bass: 1/1.25/1.5/2 (Default is "1.") Middle: 1/2 (Default is "1.") Bass DC EXT Turns Bass DC EXT on or off. Default is "OFF." If you select "ON", the bass center frequency is extended to the low register by approximately 20%. [Flat] Tone level becomes 0 (flat). Subwoofer Level Adjusts the subwoofer volume. This setting is not available when subwoofer is set to "None". See Speaker setup (P.81). Zone Control screen appears. 2 Touch [Dual Zone]. 3 Set each source as follows. [3] (Front Source, Rear Source) Select the audio source for each. [∞], [5] (Rear VOL.) Adjusts the rear channel volume. [Single Zone] Touch to turn off the dual zone function. Continued 87