Kenwood DPX500BT Quick Start Guide - Page 3

Before use 2 WARNING To prevent injury or fire, take the following precautions: • Stop the car before operating the unit. • To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. ¤ CAUTION • Adjust the volume so that you can hear sounds outside the car. Driving with the volume too high may cause an accident. • Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure to observe this precaution may result in damage to the monitor or unit." Condensation When the car is air-conditioned, moisture may collect on the laser lens. This may cause disc read errors. In this case, remove the disc and wait for the moisture to evaporate. Handling discs • Do not touch the recording surface of the disc. • Do not stick tape etc. on the disc, or use a disc with tape stuck on it. • Do not use any accessories for the disc. • Do not use any solvents to clean discs. Use a dry silicon or soft cloth. • Clean from the center of the disc and move outward. • When removing discs from this unit, pull them out horizontally. • Remove the rims from the center hole and disc edge before inserting a disc. How to reset your unit If the unit fails to operate properly, press the Reset button. The unit returns to factory settings. Notes • If you experience problems during installation, consult your Kenwood dealer. • When you purchase optional accessories, check with your Kenwood dealer to make sure that they work with your model and in your area. • Characters that conform to ISO 8859-1 can be displayed. About discs used with this unit • This unit can only play the CDs with . • The following discs cannot be used: -- Discs that are not round -- Discs with coloring on the recording surface or discs that are dirty -- Recordable/Rewritable disc that has not been finalized (For the finalization process, refer to your disc writing software, and your disc recorder instruction manual.) -- 8 cm (3 inch) disc (Attempt to insert using an adapter can cause malfunction.) Reset button English | 3