Kenwood DRV-A601W Operation Manual - Page 20

Attach The Mount To The Windshield & Start Recording

Get Kenwood DRV-A601W PDF manuals and user guides View all Kenwood DRV-A601W manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

How to use the Adhesive Mount: i. Loosen the (c) locking ring on the suction mount and pull the (e) magnetic connector out. ii. Next, loosen the (c) locking ring from the adhesive mount, and plug the (e) magnetic connector into the adhesive mount. iii. Clean the installation area on the windshield and peel off the plastic covering. Adhere it to the windshield. Loosen Tigten 3. ATTACH THE MOUNT TO THE WINDSHIELD & START RECORDING Remove the protective plastic film and select a position on the windshield where it won't distract you. Then, put the suction mount in place. Release the (b) locking lever from the mount by pulling down on it. Hold the suction mount in place and press against the window. While holding it in place, pull the (b) locking lever back to lock the mount 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
17
How to use the Adhesive Mount:
ATTACH THE MOUNT TO THE WINDSHIELD & START RECORDING
Remove the protective plastic film and select a position on the windshield where it
won’t distract you. Then, put the suction mount in place.
Release the
(b) locking lever
from the mount by pulling down on it. Hold the suction
mount in place and press against the window. While holding it in place, pull the
(b)
locking lever
back to lock the mount
Loosen the
(c) locking ring
on the suction mount and pull the
(e) magnetic
connector
out.
Next, loosen the
(c) locking ring
from the adhesive mount, and plug the
(e) magnetic connector
into the adhesive mount.
Clean the installation area on the windshield and peel off the plastic covering.
Adhere it to the windshield.
i.
ii.
iii.
3.
Loosen
Tigten