Kenwood Here2Everywhere Operating Instructions - Page 3
Safety Precautions - users manual
View all Kenwood Here2Everywhere manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Safety Precautions ! Warning ! Warning Take the following precautions to prevent fire and avoid personal injury: Take the following precautions to prevent traffic • To avoid short circuits, never put or leave any accidents and avoid personal injury: 4 • Installation must be performed according to this metallic objects (coins, tools, etc.) inside the unit. • If the unit emits smoke or strange smells, turn the installation manual. Kenwood is not responsible power off immediately and consult your Kenwood for issues arising from installations not performed dealer. according to the procedures in this manual. • Do not install the unit where it may obstruct your • Do not drop the unit or subject it to strong shocks. view through the windshield or of your vehicle's indicator displays. • If the LCD display becomes damaged or broken, do not touch the liquid crystal fluid. The fluid may • Do not install the unit where it may hinder the be dangerous to your health or even fatal. If the function of safety devices such as an airbag. liquid crystal fluid contacts your body or clothing, Doing so may prevent the airbag from functioning immediately wash it off with soap and water. properly in the event of an accident. • The installation and use suggestions contained in this manual are subject to any restrictions or limitations that may be imposed by applicable law-the purchaser should check applicable law for any restrictions or limitations before installing and/or operating this unit. • Failure to follow these safety instructions and warnings may result in a serious accident. ! Caution Take the following precautions to keep the unit in proper working order: • Be sure the unit is connected to a 12V DC power supply with a negative ground connection. • Do not open the unit. • Do not install the unit where it will be exposed to high levels of humidity, moisture, or dust. • When replacing a fuse, use only a new one with the proper rating. Using a fuse with the wrong pursuant to Part 15 of the FCC Rules. These limits rating may cause the unit to malfunction. are designed to provide reasonable protection • To prevent a short circuit when replacing a fuse, first disconnect the wiring harness. against harmful interference in a residential installation. This equipment may cause harmful interference • When drilling holes to mount the unit, make sure to radio communications if it is not installed and not to damage wiring or other systems that may used in accordance with these instructions. However, 5 be close to the mounting surface. there is no guarantee that interference will not occur Note: If the unit doesn't seem to be working properly: • Turn the unit's power off, wait 5-10 seconds, then turn the power on again. • If the unit still mis-operates, turn the unit's power off, remove it from the cradle, wait 5-10 seconds, replace it in the cradle, and turn the power back on. in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna If the problem persists, consult your Kenwood dealer. • Increase the separation between the equipment and receiver FCC Warning This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in this instruction • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected • Consult the dealer or an experienced radio/TV technician for help manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. Note: This equipment has been tested and found Cleaning the Unit If the unit becomes dirty, turn its power off and wipe it clean with a soft, dry cloth. to comply with the limits for a Class B digital device,