Kenwood KTC-H2A1 Instruction Manual - Page 5
Installation in a vehicle continued, Mounting the included, antenna - car
UPC - 019048148148
View all Kenwood KTC-H2A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation in a vehicle (continued) Note: If you're using the Kenwood CX-SR10 SIRIUS antenna, you'll need to remove the plastic housings from the antenna connectors before connecting it to the cradle-we recommend labeling the wires with their respective colors. (See pg. 9, figure 16 of the CX-SR10 Installation Manual for details). Once you've removed the housings, connect the wire that had the yellow connector to the connector on the cradle labeled "1-Sat/Terr (Main)", and connect the other one to the connector labeled "2-Terr". Mounting the included antenna 1. Find an antenna location on a metal surface at least 12" x 12". The antenna should be mounted exactly 5.5" (the length of the antenna's tail) away from the vehicle's rear window, so that only the portion of the cable protected by the tail is exposed, as shown to the right. The antenna's 3 powerful magnets will secure it to the metal surface. • Do not shorten the antenna's tail. Doing so could damage the cable, since its insulation is integrated with the tail. • Best reception is achieved with the antenna mounted on the roof; mounting on the trunk lid will work for convertibles. If the vehicle has a roof rack or skid ribs, it may be necessary to mount the antenna offcenter. 8 Here2Anywhere Instruction Manual (ver. 2) 2. Before permanently mounting the antenna and routing the cable, confirm that the antenna is mounted in a good location: a. Temporarily plug the cigarette lighter adapter into the cigarette lighter. b. cSolindneeHcteorer 2aAt nthyewrheearreoafltlhteheunwiat my ianktoesthperocpreardcleonstoacthtaint the the cradle. Press the POWER button to turn Here2Anywhere on. c. IafnytoeunrnHaeries2Arencyewivhienrge has the been properly connected SIRIUS signal (preview and the stream #184) you will hear audio. If you do not hear audio, the display will read "Acquiring Signal". Re-orient the antenna until you hear audio. (See Antenna Signal, on page 33 to use the ANTENNA SIGNAL screen to aim the antenna.) • Make sure the vehicle is not in garage, or somewhere the satellite signal could be blocked 3. cTurarndleH;eurnep2Alungytwhheecreig'sareptotewleigr hoteffr and remove adapter from it the from the cigarette lighter; unplug the antenna from the cradle. 4. Remove the yellow protective backing from the adhesive strip and firmly adhere it to the underside of the antenna tail. (Do not remove the red protective backing at this time.) 5. Once the strip is adhered to the tail, remove the red protective backing from the adhesive and firmly adhere the tail to the vehicle. Here2Anywhere Instruction Manual (ver. 2) • At room temperature, maximum adhesion usually occurs within 72 hours. During this period, car washes and other contact with the antenna and tail should be avoided. 6. Route the exposed portion of the antenna cable from the end of the tail to the vehicle's interior by tucking it underneath the rubber molding around the vehicle's rear window, as shown below. 9