Kenwood KTC-HR300 Instruction Manual - Page 12
Select Switch - install
UPC - 019048183231
View all Kenwood KTC-HR300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installation Connecting Wires to Terminals ⁄ • Do not remove the ferritic core attached to the cable. Control Unit (5L connector) Control Unit (KAB connector) Accessory2 ⁄ • The unit can only be connected to a control unit with either 5L or KAB connector. KTC-HR300 Antenna Cable (Accessory1) To FM/AM antenna SELECT SWITCH KAB Set "SELECT SWITCH" 1 depending on a connector type of a control unit to be used. When connecting to the control unit with 5L connector, set this switch down, and 5L when KAB connector set the switch up (ON). ⁄ • KAB Connector units DDX5034, DDX5034BT, DDX512, DDX514, DDX712, DDX812, DNX5120, DNX512EX, DNX5140, DNX6000EX, DNX6140, DNX7120, DNX8120, KVT-512, KVT-514 (As of January, 2009) Installation 12 | KTC-HR300 Accessory3 Carpet Remove the backing from the velcro strips (Accessory3) and attach it to the bottom of the unit. Install the switching unit on the carpet. ¤ • Please do not install the unit near the dashboard, the rear tray, or other important components. Doing so could lead to injury or accident should the unit come off due to a shock and strike a person or an important component. ⁄ • Do not stick the velcro tape over the serial number.