Kenwood TH-D74A User Manual - Page 44
Pitch Frequency, Cw Reverse, Led Control, Vox On Busy
View all Kenwood TH-D74A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
VOX on Busy You can configure the transceiver to force VOX transmission even if the transceiver is receiving a signal. 1 Access Menu No. 153. LED CONTROL This function turns off the BUSY LED to reduce the consumption of battery power. With the default setting, the BUSY LED is always on when receiving FM radio broadcasts. 1 Access Menu No. 181. 2 Select [On] or [Off]. [Off]: Do not operate VOX when the operation band is busy. [On]: Operate VOX when the operation band is busy. Note: ◆◆ You can press [PTT] or [CALL] (if 1750 Hz is programmed) to transmit, regardless of the setting in Menu No. 153. PITCH FREQUENCY This function set the pitch frequency during CW reception. 1 Access Menu No. 170. 2 Press [ENT]. Each press change the check mark. RX (Check): The LED is on when receiving in bands A and B (including when receiving an FM radio broadcast). (Uncheck): The LED is not on when receiving in normal operation mode (including when receiving an FM radio broadcast). FM Radio (Check): The LED is on when receiving an FM radio broadcast in FM radio mode. (Uncheck): The LED is not on when receiving an FM radio broadcast in FM radio mode. 3 Press [A/B]. The change of a check mark is confirmed. 2 Select among from [400] to [1000] Hz. CW REVERSE You can select the USB side [Normal] or LSB side [Reverse]. 1 Press [MODE] to set CW mode. 2 Access Menu No. 171. 3 Select [Reverse] or [Normal]. 12-6