Kenwood VRS-7100 Instruction Manual - Page 33

Listening to radio broadcasts The receiver can store up to 40 stations in the memory and recall them by one-touch operation.Radio stations can be classified into RDS (Radio Data System) stations and other stations. To listen to or store RDS stations in the preset memory see "Using RDS (Radio Data System) (For Europe)". fi Tuning (non-RDS) radio stations Presetting radio stations INPUT SELECTOR BAND AUTO/MONO INPUT SELECTOR BAND AUTO/MONO TUNER RCV Mode Tune - 1 / + ¡ Band MULTI CONTROL %/fi ENTER Multi %/fi Auto 7 1 Use the INPUT SELECTOR key (or the TUNER key) to select the tuner. 2 Use the BAND key (or the Band key) to select the desired broadcast band. Each press switches the band. -- 88)) 3 Use the AUTO/MONO key (or the Auto 7 key) to select the desired tuning method. Each press switches the tuning method to either auto or manual tuning. 1 Auto tuning: The "AUTO" indicator lights up 2 Manual tuning: The "AUTO" indicator goes off "AUTO" indicator lights up in the display. 88)) ÷ Normally, set to "AUTO" (auto tuning). If the radio waves are weak and there is a lot of interference, switch to manual tuning. (With manual tuning, stereo broadcasts will be received in monaural.) 4 Use the MULTI CONTROL % / fi (or Multi % / fi keys, Tune +/ - keys) to select the station. 8755 "TUNED" indicator is displayed when a station is received."ST." indicator lights when a broadcast is being received in stereo. Auto tuning: The next station is tuned automatically. Manual tuning: Use the MULTI CONTROL % / fi (or Multi % / fi ) to select the desired station. MULTI CONTROL %/fi ENTER Collective presetting of stations (For U.S.A., Canada and Australia) 1 Use the INPUT SELECTOR key (or the TUNER key) to select the tuner. 2 Use the BAND key (or the Band key) to select he broadcast band to "FM". 3 Press and hold the ENTER for more than 2 seconds. AU T O PR E S E T The blinking "AUTO" display and blinking "PRESET" display appear alternately. ÷ A maximum of 40 stations of the band presently being received will be preset. ÷ Use the Manual Preset function if a desired FM station cannot be preset using the Auto Preset function or when it is required to preset AM stations. Presetting radio stations manually 1 Tune to the station you want to store. 2 Press the ENTER while receiving the station. )1 8755 Proceed to step 3 within 5 seconds. (If more than 5 seconds elapse, press the ENTER again). 3 Use the MULTI CONTROL % / fi (or the Multi % / fi keys) to select one of the station presets (1 - 40). 4 Press the ENTER again to confirm the setting. • Repeat steps 1, 2, 3, and 4 to store as many stations as necessary. • If you store a station at a previously used preset, the old station will be replaced by the new one. 33 EN