Kenwood VRS-7100 Instruction Manual - Page 8

Setting up the system CAUTION Make sure that the power cord plug is disconnected from the AC wall outlet before proceeding to connections. Also be sure to disconnect the power cord plug from the AC wall outlet before changing connections. For the connections of other system components, see pages 9 to 18. When connecting an associated system component, be sure to read its instruction manual. Microcomputer malfunction If operation is not possible or an erroneous display appears,even though all connections have been made properly, reset the micro computer referring to "In case of difficulty". P Notes 1. Be sure to turn off the system components before connecting them. 2. Be sure to insert every connection cable completely into the jack. Incomplete connection may result in absence of audio output or production of noise. 3. Be sure to disconnect the power cord from the AC wall outlet before inserting or removing a connection cable. 4. Installation of outdoor antenna is a dangerous work. Please have your dealer or a specialized technician install it. 5. Select the speaker installation locations with care. If a speaker is installed near a source of magnetism including a magnet, the mutual interference with the speaker may produce color irregularities on the TV screen. Analog audio connections Audio connections are made using RCA pin cords. These cables transfer stereo audio signal in an "analog" form. This means the audio signal corresponds to the actual audio of two channels. These cables usually have 2 plugs on each end,one red for the right channel and one white for the left channel. These cables are to be prepared separately by the user. CAUTION Be sure to adhere to the following, or proper ventilation will be blocked causing damage or fire hazard. ÷ Do not place any objects impairing heat radiation onto the top of the unit. ÷ Leave some space around the unit (from the largest outside dimension including projection) equal to or greater than, shown below. Top panel : 50 cm Side panel : 10 cm Back panel : 10 cm 8 EN Input mode settings DVD, VIDEO 1, VIDEO 2, AUX and GAME inputs each include jacks for digital audio input and analog audio input. The initial factory settings for audio signal playback for DVD, VIDEO 1, VIDEO 2, AUX and GAME are full auto. After completing connections and turning on the receiver,follow the steps below. INPUT SELECTOR Input Mode Input Selector keys 1 Use the INPUT SELECTOR key (or Input Selector keys) to select DVD, VIDEO 1, VIDEO 2, AUX or GAME. 2 Press the Input Mode key. Each press switches the setting as follows: 1 "F-AUTO": Auto detect ("AUTO DETECT" indicator lights up) 2 "D-MANUAL": Fixed to digital input ("DIGITAL" indicator lights up) 3 "ANALOG": Fixed to analog input * ("AUTO DETECT", "DIGITAL" indicator goes off) * Can not be selected for DTS playback. Auto detect: In "F-AUTO (FULL AUTO)" mode ("AUTO DETECT" indicator light up), the receiver detects the digital or analog input signals automatically. The receiver will select the input mode and listening mode automatically during playback to match the type of input signal (Dolby Digital, PCM, DTS) and the speaker setting. , The "DIGITAL" indicator lights up when a digital signal is detected. The "DIGITAL" indicator is extinguished when no digital signal is detected. Fixed to digital input: Select this mode if you want to keep the decoding condition (Dolby Digital, DTS, PCM, etc.) in the current listen mode. When "D-MANUAL (DIGITAL MANUAL)" mode is selected, the set listen modes may be changed automatically depending on the listen mode. , Fixed to analog input: Select this setting to play analog signals from a VCR, etc. If the Input Mode key is pressed quickly, sound may not be produced. Press the Input Mode key again.