Kenwood VRS-7100 Instruction Manual - Page 61

In case of difficulty Tuner Symptom Radio stations cannot be received. Remedy ÷ Connect an antenna properly. ÷ Set the broadcast band properly. ÷ Tune the frequency of the desired station. * ‹ Interference. ÷ Install the outdoor antenna away from the road. ÷ Turn off the power to the appliance. ÷ Install the receiver farther away from the TV. A station which was preset cannot be received by pressing the corresponding numeric key. ÷ Preset a station with a receivable frequency. Remote control unit Symptom Control of another component is ÷ Register its setup code correctly. impossible. Remedy t Remote control operation is not possible. ÷ Press the input selector key and select the optimum control mode. ÷ Replace with new batteries. ÷ Point the remote control unit to the remote sensor of the receiver. ( ÷ Connect them properly referring to "Setting up the system" ÷ The remote control has not been set to the operation mode for the component you wish to control. Press the source select keys or SRC Power key to activate the operation mode for the component you want to control before operation. y Memory back-up function If the power supply to the receiver is shut down for about a day or more, the following settings will be reset to the initial conditions. Please be careful. ÷ Power mode = OFF ÷ Volume level = - 66 dB ÷ Dimmer level = OFF (Brightest condition) ÷ Broadcast band = FM ÷ Frequency setting = 87.50 MHz ÷ Tuning mode = AUTO For the U.S.A. Note to CATV system installer This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. For the U.S.A. FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio / TV technician for help. For the U.S.A. As an ENERGY STAR® Partner, Kenwood Corporation has determined that this products meets the ENERGY STAR® guidelines for energy efficiency. This product can save energy. Saving energy reduces air pollution and lowers utility bills. 61 EN