Kenwood VRS-7100 Instruction Manual - Page 60
In case of difficulty - problem
UPC - 019048153548
View all Kenwood VRS-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
In case of difficulty Resetting the Microcomputer The microcomputer may malfunction (unit cannot be operated, or shows an erroneous display) if the power cord is unplugged while the power is ON, or due to some other external factor. If this happens, execute the following procedure to reset the microcomputer and return the unit to its normal operating condition. Unplug the power cord from the wall outlet, then plug it back in while holding down the POWER ON/STANDBY (For U.S.A and Canada) or ON/STANDBY key (For Europe and Australia). ÷ Please note that resetting the microcomputer will clear the contents of the memory and returns the unit to the state it was in when it left the factory. Amplifier Symptom No sound from the speakers. Remedy ÷ Connect them properly referring to "Connecting the speakers" ÷ If muting is ON, release it. ÷ If headphones are connected, disconnect them. ÷ Press the Input Mode key to select to full auto mode. ÷ Check if the assignment of digital audio input jacks is correct. # ⁄ º 8 • Sound is not output from the speaker, or their sound is very small. ÷ Connect them properly referring to "Connecting the speakers" ÷ See "Speaker settings" and check if the setting for all of the speakers is correct. ÷ Select a surround mode. ÷ Adjust the speaker levels using the test tone. # ¢ § The standby indicator blinks and sound is not output. ÷ The protection circuitry is activated because speaker cords are short-circuited. Disconnect the power cord from the AC wall outlet, switch the receiver OFF, remove the short-circuiting and turn the receiver ON again. ÷ The protection circuitry is activated because the output power is too high. Turn this unit OFF then ON again and reduce the output volume level. ÷ The protection circuitry activated due to extreme rise in temperature. Turn this unit OFF then ON again and reduce the output volume level. ÷ The protection circuitry is activated because the impedance of the speakers in use is lower than specified. Use speakers of the specified impedance. The audio and video of a different ÷ Check if the assignment of digital audio input jacks and component video jacks is correct. • channel are output. The video is not output. ÷ Connect the video source to be played to this unit and this unit to the monitor TV using the same type of cords (Component video cords, S VIDEO cords or yellow RCA video cords) correctly. 0 Audio cannot be recorded. ÷ Connect the equipment correctly by referring to "Connecting video components, audio components" and "Digital connections". 0@ ÷ If it is the digital audio that you attempt to record, set up the unit correctly by referring to "Recording music in REC mode". ¤ A video source cannot be recorded normally. ÷ Copy-guarded video software cannot be recorded. ÷ The S VIDEO and component video inputs cannot be recorded. Connect the video source to the yellow RCA video jack. 0 When playing a digital source signal, the sound is cut off soon after it starts. ÷ There are many possible causes for this problem, depending on the type of player used. Switch the input mode to DIGITAL MANUAL during playback of the digital source, and restart the playback from the beginning. 8 Dolby Digital or DTS audio software ÷ Check if the digital output setting of the digital audio player is correct. cannot be played in multi-channel audio. The audio of a satellite digital ÷ With certain broadcasting, the audio cannot be switched on the receiver. In this case, switch the broadcasting cannot be switched. audio on your satellite digital tuner. The input for the unit is set automatically ÷ The GAME mode function is activated. to "GAME" when the unit is turned ON. ¶ 60 EN