Kenwood VRS-7100 Instruction Manual - Page 6

Names and functions of parts Main unit Input mode indicators CLIP indicator MUTE indicator Listen mode indicators ACTIVE EQ indicator, DUAL SOURCE Input indicator, 96 kHz fs indicator Speaker selection indicators, Input channel indicators (The Input channel indicators lights up to indicate the channels contained in the input signal. The "S" indicator lights when the surround component consists of a single channel.) For Europe and Australia Frequency display, Input display, Preset channel display, Listen mode display Display 12 34 5 Dolby Headphone mode indicator, Dolby Virtual Speaker mode indicator AUTO indicator, ST. indicator, TUNED indicator, Sleep Timer indicator, TONE indicator For Europe Only : RDS indicator, PTY indicator 6 78 9 0 % $ View when the GAME/ FRONT AUX jack # cover is open. @ ! 1 (For the U.S.A. and Canada) POWER ON/STANDBY key ¢ Use to turn the power ON/STANDBY. (For Europe and Australia) ON/STANDBY key ¢ Use to turn the power ON/STANDBY. STANDBY indicator Lights when the power is in the standby mode. 2 DUAL SOURCE VOLUME 5/∞ keys º Use to adjust the volume in the DUAL SOURCE mode. DUAL SOURCE INPUT key º Use to select the input for the DUAL SOURCE mode. DUAL SOURCE ON/OFF key º Use to switch the DUAL SOURCE mode ON/ OFF. 3 BAND key ‹ Use to select the broadcast band. 4 AUTO/MONO key ‹ Use to select the auto or manual tuning mode. 5 Dolby D indicator , Lights when the receiver is in the Dolby Digital mode. DTS indicator , Lights when the receiver is in the DTS mode. Dolby H indicator · Lights when the Dolby H mode is ON. DUAL SRC indicator º Lights when the DUAL SOURCE mode is ON. 6 Joystick MULTI CONTROL Use to control a variety of settings. Use to tuning of radio broadcasting. MULTI CONTROL Use to control a variety of settings. Use to selection of preset radio stations. ENTER ¡£‹ Use to control a variety of settings. Use to presetting of radio stations. 7 MULTI CH indicator , Lights during multi-channel playback. 8 ACTIVE EQ key ⁄ Use to select ACTIVE EQ's setting. 9 VOLUME CONTROL knob ª Use to adjust the receiver volume. 0 INPUT SELECTOR key ª Use to select input sources. ! SETUP key ¡£¤ Use to select the speakers'settings etc. Use to select the REC MODE. @ LISTEN MODE key , Use to select the listening mode. # GAME jacks &¶º $ FRONT AUX jacks &º % PHONES jack º Use for headphone listening. Standby mode While the standby indicator is lit, a small amount of power is supplied to the system to back up the memory. This is called standby mode. Under the condition, the system can be turned ON by the remote control unit. 6 EN