KitchenAid KEBC167VSS Use & Care Guide - Page 5

ELECTRONIC OVEN CONTROL This manual covers different models. The oven you have purchased may have some or all of the items listed. The locations and appearances of the items shown here may not match those of your model. AB C D EF G H I A. Oven display symbol B. Heat settings C. Oven display D. Start/stop time E. Number pads F. Control lock J K L G. Time of day/timer display H. Start I. Oven settings J. EasyConvect™ conversion K. Timed cooking MN O PQ L. Convect full meal M. Oven light N. Clock O. Minute timer P. Surface light Q. Cancel/off Display When power is first supplied to the oven, everything on the display will light up for 5 seconds. Then, "PF" will appear on the oven display and a time of day will appear on the Time of Day display. Press CANCEL/OFF to clear the oven display. If "PF" appears at any other time, a power failure has occurred. Press CANCEL/OFF and reset the clock if needed. Oven Display When the oven is in use, this display shows the oven temperature, heat source and start time. In addition, during Timed Cooking, this display shows a vertical bar and time countdown and the stop time (if entered). If "Err" appears on the oven display, an invalid pad was pressed. Press CANCEL/OFF and retry your entry. When the ovens are not in use, this display is blank. Time of Day, Timer Display This display shows the time of day or Timer countdown. Start The START pad begins all oven functions except the Timer, Control Lock and Sabbath Mode. If not pressed within 5 seconds after pressing a pad, "START?" will appear on the oven display as a reminder. If not pressed within 4 or 5 minutes after pressing a pad, the oven display will return to inactive mode (blank) and the programmed function will be canceled. Cancel/Off The CANCEL/OFF pad stops the oven functions except for the Clock, Timer, Control Lock and Sabbath Mode. The cooling fan may continue to operate even after an oven function has been canceled, depending on the oven temperature. Clock This is a 12-hour clock and does not show a.m. or p.m. To Set: Before setting, make sure the oven, Timer and Timed Cooking are off. 1. Touch CLOCK SET/START. 2. Touch the number keys to set the time of day. 3. Touch CLOCK SET/START again. To Remove/Return Time of Day from Display: Press and hold CLOCK SET/START for 5 seconds. Repeat to redisplay. The time should not have to be reset. Tones Tones are audible signals, indicating the following: One tone I Valid pad press I Oven is preheated I Function has been entered Three tones I Invalid pad press Four tones I End of cycle I Reminder, repeating each minute after the end-of-cycle tones 5