KitchenAid KUDD01SSSS Installation Instructions - Page 7
Install the Drain Hose - dishwasher
View all KitchenAid KUDD01SSSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Install the Drain Hose A drain hose extension kit, part no. 8194400, will extend the drain hose to a length of up to 141 ³⁄₄" (360.05 cm). Do not extend beyond this length. The maximum drain height is 37 ¹⁄₂" (95.25 cm). Option 1: Sink drain waste tee connection 1. Route the drain hose as shown and press the hose into the drain hose support. 2. Decide if the drain hose needs to be trimmed. If it does, trim it. NOTE: The drain hose connector must not support the weight of excess hose length. Keep hose as fully extended as possible. wire clip 3. Slip a wire clip over the drain hose. Push the hose into the drain hose connector firmly, 5 clicks. 4. Position the wire clip between the two positioning ribs on the drain hose connector. drain hose connector 5. Attach the drain hose connector to the waste tee using the supplied hose clamp. 6. Attach the drain hose support bracket to the cabinet with a #8 Phillips head screw at the height shown below. IMPORTANT: A drain loop must be provided as shown in the Installation Instructions. Keep hoses as fully extended as possible to prevent sagging. Any excess length of hose should be kept on the dishwasher side of the drain loop. Option 2: Garbage disposal connection 1. Route the drain hose as shown and press the hose into the drain hose support. 2. Decide if the drain hose needs to be trimmed. If it does, trim it. NOTE: The drain hose connector must not support the weight of excess hose length. Keep hose as fully extended as possible. 3. Slip a wire clip over the drain hose. Push the hose into the drain hose connector firmly, 5 clicks. wire clip 4. Position the wire clip between the two positioning ribs on the drain hose connector. drain hose connector 5. Attach the drain hose connector to the garbage disposal using the supplied hose clamp. 6. Attach the drain hose support bracket to the cabinet with a #8 Phillips head screw at the height shown below. IMPORTANT: A drain loop must be provided as shown in the Installation Instructions. Keep hoses as fully extended as possible to prevent sagging. Any excess length of hose should be kept on the dishwasher side of the drain loop. drain hose support drain hose support garbage disposal 6" (15.2 cm) minimum valve 27-1/2" - 32-1/4" (70 cm - 82 cm) 6" (15.2 cm) minimum waste waste tee water supply 8" (20.3 cm) min. bend radius from valve valve 27-1/2" - 32-1/4" (70 cm - 82 cm) waste water supply 8" (20.3 cm) min. bend radius from valve Keep drain hose straight, as shown. Keep drain hose straight, as shown. 7