Kodak I1420 User Guide - Page 43
Install each new tire by gently stretching it over the core.
UPC - 041778272671
View all Kodak I1420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
4. Holding onto the separator module, rotate the release lever back so you can access the separator roller. NOTE: Use caution as the separator module is spring-loaded and will snap back if you do not hold it in place. 5. Hold onto the separator module in this position with one hand, and with the other hand remove the separator roller. 5-12 6. Gently lower the separator module release lever back into place and set the separator module aside. 7. Remove each tire by sliding it off the core. 8. Install each new tire by gently stretching it over the core. IMPORTANT: Do not overstretch the tire; it may tear. Make sure that the tire is centered on the core and lies flat. 9. Reinstall the core (the direction does not matter). 10. Reinstall the separator module. 11. Close the scanner cover with both hands; push it down firmly until it latches into place. A-61550 February 2010