Konica Minolta AccurioPress C6100 IC-314 User Guide - Page 113

Creating a profile from existing color chart measurements 103 15. In the message that appears, click OK. 16. Click Finish to close the Profiling Tool. Creating a profile from existing color chart measurements Requirements: The must already be calibrated. 1. From the Tools menu, select Profiling Tool. 2. Select Load existing measurements. 3. Click Next. 4. In the Paper Stock list, select the paper stock for the profile. 5. In the Screening list, select the screening method for the profile. 6. Click Load. 7. In the Open dialog box, locate the measurement file, and then click Open. 8. Click Next. 9. Click Create Profile. Note: This process might take a few minutes. 10. In the Profile Name box, type a new name for the profile, or keep the name that the Profiling Tool automatically created based on the screening method. 11. To define the location for saving the destination profile, select one of the following options: ○ Profile Manager-The profile automatically appears in the Profile Manager area. ○ Other-Saves the profile in a specified location, which you can import later to the Profile Manager area in the Resource Center. 12. Click Save to save the profile. 13. In the message that appears, click OK. 14. Click Finish to close the Profiling Tool. Creating a G7 profile from existing color chart measurements A G7 destination profile is a profile associated with G7 calibration algorithm. When a G7 calibration is applied to your job, a G7 destination profile must be used. Requirements: The press must already be calibrated.