Konica Minolta AccurioPress C6100 IC-314 User Guide - Page 117
Troubleshooting profiling
View all Konica Minolta AccurioPress C6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Troubleshooting profiling 107 5. Depending on your measuring device, complete the measuring process following the steps in the wizard, and also refer to steps earlier in this chapter. Note: If you are using the Intelligent Quality Optimizer to measure the chart, after the chart is printed and measured automatically, continue to the next step. 6. (Optional) To save the measurement file and load it at a later time, locate a folder, and in the Save in box, type a name for the measurement file and click Save. 7. Click Next. 8. Click Create Profile. Note: This process might take a few minutes. 9. In the Profile Name box, type a new name for the profile, or keep the name that the Profiling Tool automatically created based on the screening method. 10. To define the location for saving the destination profile, select one of the following options: ● Profile Manager-The profile automatically appears in the Profile Manager area. ● Other-Saves the profile in a specified location, which you can import later to the Profile Manager area in the Resource Center. 11. Click Save to save the profile. 12. In the message that appears, click OK. 13. Click Finish to close the Profiling Tool. Troubleshooting profiling Resolve common problems that can occur during the profiling process. Message Wrong measured strip Information and solution The data received for the measured strip does not match the expected results for this strip. Make sure that you are measuring the correct strip. Perform one of the following actions: ● Click OK to measure the strip again. ● Click Cancel to continue the process. Strip measurement failed A red X icon appears. Repeat the measurement.