Konica Minolta AccurioPress C6100 IC-314 User Guide - Page 196

186 Chapter 8-Production workflows Parameter Marks and barcodes Print parameters Note: The IPDS and AFP workflows are available only with the Trans Pack. Option Description Marks and barcodes Enables you to add a mark set that was defined in the Resource Center, and define on which sheets the marks appear. Provides the following options: ● All-Prints the marks on each sheet in your job ● Repetition-Prints the marks according to the frequency that you define-for example, if you set the repetition to 3, the marks will be printed every third sheet ● Sheet Range-Prints the marks according to the sheet range that you defined. Provides the following options: ○ Type a range of sheets with a hyphen between the starting and ending numbers in the range-for example, 1-5 ○ Type a range of sheets with a hyphen or comma between the starting and ending numbers, and where the last sheet=n ● 1,n (first and last sheets) ● n-1 (the sheet before last) ● n- (the integer stands for the number of sheets before the last sheet) Note: The sheet range option is applicable to finishing marks, registration marks and bar codes. Image alignment Image alignment To find out how to define marks and bar codes, see the section on using mark sets. Position of the image relative to the defined printable area: ● Left-Printed image is aligned to the top left side of the printable area ● Right-Printed image is aligned to the top right side of the printable area ● Center-Image is placed in the center of the printable area ● Bottom-Image is aligned to the bottom center of the printable area