Kyocera TASKalfa 205c Fax System (U) Operation Guide Rev-1 - Page 187
Indicators During Sending/Receiving Operation, Responding to an Attention Indicator Flashes
View all Kyocera TASKalfa 205c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
Troubleshooting > Indicators During Sending/Receiving Operation Indicators During Sending/Receiving Operation The Processing and Memory indicators show the fax transmission status. • The processing indicator blinks during fax transmission and reception. • The Memory indicator blinks when source data is being stored in memory for memory transmission. • The Memory indicator is lit when there is source data stored in the memory for delayed transmission. Responding to an Attention Indicator Flashes If an attention indicator flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated on the touch panel when [Status/Job Cancel] is pressed or the attention indicator flashes for 1.5 seconds, check the following. Symptom Checkpoints Corrective Actions Reference Page Cannot send fax. Is the modular cord connected Connect the modular cord correctly. - correctly? Is Permitted FAX No. or Permitted ID No. registered correctly? Check Permitted FAX No. and Permitted 9-9 ID No. Has a communication error occurred? Check error codes in the TX/RX Result Report and Activity Report. If the error code starts with "U" or "E", perform the corresponding procedure. 10-6 Is the destination FAX line busy? Send again. - Does the destination FAX Send again. - machine respond? Is there an error other than above? Contact your Service Representative. - 10-2