LG DLGX3701W Owners Manual - Page 17
Stacking the Dryer, Stacking Kit Installation
View all LG DLGX3701W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Stacking the Dryer Stacking Kit Installation This stacking kit includes: ••Two (2) side rails ••One (1) front rail ••Four (4) screws INSTALLATION 17 To ensure safe and secure installation, please observe the following instructions. 1 Make sure the surface of the washer is clean and dry. Remove paper backing from the tape on one of the stacking kit side brackets. ENGLISH Tools Needed for Installation: ••Phillips screwdriver 2 Fit the side bracket to the side of the washer top as shown in the below illustration. Firmly press the adhesive area of the bracket to the washer surface. Secure the side bracket to the washer with a screw on the back side of the bracket. Repeat steps 1 and 2 to attach the other side bracket. WARNING To reduce the risk of electrical shock, fire, explosion, property damage, serious injury or death, follow basic precautions, including the following: • The weight of the dryer and the height of installation make this stacking procedure too risky for one person. Two or more people are required when installing the stacking kit. • Do not use the stacking kit with a gas dryer in potentially unstable conditions such as a mobile home. • Place the washer on a solid, stable, level floor capable of supporting the weight of both appliances. • Do not stack the washer on top of the dryer. • If appliances are already installed, disconnect them from all power, water, or gas lines and from draining or venting connections. 3 Place the dryer on top of the washer, fitting the dryer feet into the side brackets as illustrated. Avoid finger injuries; do not allow fingers to be pinched between the washer and dryer. Slowly slide the dryer toward the back of the washer until the side bracket stoppers catch the dryer feet. 4 Insert the front rail between the bottom of the dryer and the top of the washer. Push the front rail toward the back of the washer until it comes in contact with the side rail stoppers. Install the two remaining screws to secure the front rail to the side rails.