LG LSC27910ST Owner's Manual (English) - Page 8

REFRIGERATOR INSTALLATION Removing the left (freezer) door with water line connection. • Pull up the water feed tube while pressing area (Figure 1) as shown in the figure below. • NOTE:If a tube end is deformed or abraded, trim the part away. Disconnecting the tube under the door causes about 1.5 liters water to flow out. Put a large container at end of tube to prevent water from draining onto the floor. (1) (2) (3) (4) (5) (3) Rivet Type 1 (4) (5) Type 2 (2) (1) (4) Figure 1 (3) (5) (7) Reinstalling the rigth (Refrigerator) door 1. Place the door onto the lower hinge pin. 2. Fit top hinge (4) over hinge lever latch (5) into place. Rotate lever (3) counterclockwise to secure hinge. 3. Rotate the hinge lever (3) clockwise. Lift the top hinge (4) free of the hinge lever latch (5). NOTE: Regardless the type of hinge lever (3); type1: without rivet or type 2: with rivet the removal process is the same. 4. Hook tab on switch side of corner under edge of wire opening in cabinet top. Position cover (2) into place. Insert and tighten cover screw (1). (2) (1) (5) (6) (7) (6) Rivet (3) (4) (7) Type 1 Type 2 1. Open the door. Remove the top hinge cover screw (1). 2. Use a flat blade screwdriver to pry back the hooks (not shown) on the cabinet underside of the cover (2). Lift up the cover. (5) (6) (7) Type 1 (5) (6) Rivet Type 2 Reinstalling the left (Freezer) door 3. Disconnect all the wire harnesses (3). 4. Remove the grounding screw (4). 1. Feed the water tubes through the lower hinge pin and place the door onto the lower hinge pin. 5. Rotate hinge lever (5) counterclockwise. Lift the top hinge (6) free of the hinge lever latch (7). 2. Fit top hinge (6) over hinge lever latch (7) and into place. Rotate lever (5) clockwise to secure hinge NOTE: Regardless the type of hinge lever (5); type1: without rivet or type 2: with rivet the removal process is the same. NOTE: Regardless the type of hinge lever (5); type1: without rivet or type 2: with rivet the removal process is the same. CAUTION: When lifting the hinge free of the latch, be careful that the door does not fall forward. 3. Install the grounding screw (4) and connect all the wire harnesses (3). 6. Lift the door from the lower hinge pin being careful to pull the water lines through the lower hinge pin. 4. Hook tab on door switch side of cover (2) under edge of wire opening in cabinet top. Position cover into place. Insert and tighten cover screw (1). 7. Place the door, inside facing up, on a nonscratching surface. 5. Reconnect the water tubes by inserting the tubes into the connectors. 8