LG LTWS24223S Owners Manual - Page 19

Water Filter

Get LG LTWS24223S PDF manuals and user guides View all LG LTWS24223S manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

WATER FILTER WATER FILTER (On some models) It is recommended that you replace the water filter. • Approximately every 6 months. • When the Filter Exchange indicator turns on. • When the water dispenser output decreases. • When the ice cubes are smaller than normal. REMOVE THE OLD WATER FILTER. 3. Push the water filter up into the filter receptacle and rotate it clockwise to lock it into place. Once installed correctly, the lock symbol should be facing you and you should not be able to rotate the filter clockwise any more. NOTE: Replacing the water filter causes a small amount of water (around 1 oz. or 25 cc) to drain. Wrap a cloth around the front end of the water filter cover to collect any water. Hold the water filter upright, once it is removed, to leaking prevent any remaining water from spilling out of the water filter. NOTE: After installation, if you notice that the lock symbol is not facing you or you can continue to rotate the filter clockwise; remove the filter and repeat installation to prevent water leaks. AFTER INSTALLING THE WATER FILTER: 1. Replace the shelf to the initial position. 1. Make sure to turn o the household water supply. 2.Turn on household water supply. 2. Turn the filter counterclockwise and then pull down and out. 3. Dispense 2.5 gallons (9.46 liters) of water to purge the Make sure to rotate the filter down completely before pulling system, depressing and releasing the dispenser pad in it out of the manifold hole. cycles of 30 seconds ON and 60 seconds OFF. Open the refrigerator door and check the shelf area for water leaks. NOTE: The substitute cap must be retained for the future. If the filter is removed and not replaced, it is necessary to reinstall the substitute cap to prevent water leaks from the filter housing. REPLACE WITH A NEW WATER FILTER 1. Remove the red cap from the filter. Replacement Filter: ADQ72910907. 2. Hold the filter with the unlock symbol facing towards you, as shown in the picture below. Insert the filter into the filter receptacle on the left side of the refrigerator compartment. 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
17
WATER FILTER
AFTER INSTALLING THE WATER FILTER:
WATER FILTER (On some models)
It is recommended that you replace the water filter.
2. Turn the filter
counterclockwise and then pull down and out.
Make sure to rotate the filter
down completely before pulling
it out of the manifold hole.
Dispense 2.5 gallons (9.46 liters) of water to purge the
system, depressing and releasing the dispenser pad in
cycles of 30 seconds ON and 60 seconds OFF. Open the
refrigerator door and check the shelf area for water leaks.
2. Hold the filter
with the unlock symbol
facing towards you,
as shown in the picture below. Insert the
filter into the filter
receptacle on the left side of the refrigerator compartment.
NOTE: Replacing the water filter
causes a small amount of
water (around 1 oz. or 25 cc) to drain. Wrap a cloth around
the front end of the water filter
cover to collect any water.
Hold the water filter
upright, once it is removed, to leaking
prevent any remaining water from spilling out of the water
filter.
NOTE: After installation, if you notice that the lock symbol
is not facing you or you can continue to rotate the filter
clockwise; remove the filter
and repeat installation to
prevent water leaks.
3. Push the water filter
up into the filter
receptacle and rotate
it clockwise to lock it into place. Once installed correctly, the
lock symbol
should be facing you and you should not be
able to rotate the filter clockwise any more.
NOTE: The substitute cap must be retained for the future.
If the filter
is removed and not replaced, it is necessary to
reinstall the substitute cap to prevent water leaks from the
filter housing.
•
Approximately every 6 months.
•
When the Filter Exchange indicator turns on.
•
When the water dispenser output decreases.
•
When the ice cubes are smaller than normal.
REMOVE THE OLD WATER FILTER.
REPLACE WITH A NEW WATER FILTER
1. Make sure to turn o
ff
the household water supply.
1. Remove the red cap from the filter.
1. Replace the shelf to the initial position.
2.Turn on household water supply.
3.
Replacement Filter: ADQ72910907.