LG LTWS24223S Owners Manual - Page 7
Warning, Refrigerator Installation
View all LG LTWS24223S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
REFRIGERATOR INSTALLATION WARNING EXCESSIVE WEIGHT HAZARD Use the assistance of two or more persons to move or install the refrigerator. Not following these instructions may cause injury to the back and other parts of the body. UNPACKING Before installing your refrigerator, remove any tape or temporary stickers. Do not remove any stickers that feature warnings, the model serial number or the technical label of the product located on the back of the refrigerator. NOTE: Remove protective film on doors before plugging in the unit (on some models). To remove adhesive tape residue, rub it well with your fingers and a little liquid detergent. Clean with warm water and let dry. INSTALLATION 1. Avoid placing the unit near heat sources, direct sunlight, or humidity. 2. To avoid vibration, the unit should be leveled and placed on even floor. If needed, adjust the leveling screws to compensate for an unleveled floor. The front should be slightly taller than the rear to ensure that the doors close properly. The leveling screws can easily be turned by slightly tilting the front of the refrigerator, turning the leveling screws clockwise ( ) to raise it and counter-clockwise ( ) to lower it. 3.Install the refrigerator in an area between 55 °F (13 °C) and 110 °F (43 °C). If the surrounding temperature is lower or higher than previously mentioned, it can adversely affect the unit. CAUTION: Avoid placing the unit near heat sources, direct sunlight or humidity. Do not use sharp instruments, rubbing alcohol, flammable liquids or abrasive cleaning products to remove the adhesive tape or glue. These products can damage the surface of your refrigerator. For more information, see the section on "Important Safety Instructions". The shelves come already installed in their factory position. Remove the shelves and replace them according to your spacing needs. Moving Your Refrigerator: Your refrigerator is extremely heavy. Make sure you protect the floor when moving your refrigerator for cleaning or servicing. Always pull your refrigerator straight out when moving it. Do not shift from side to side or "walk" the refrigerator when attempting to move it as this can cause damage to the floor. ONCE INSTALLED 1. Carefully clean your refrigerator and remove and dust accumulated during shipping. 2.Install accessories such as the ice bin, door racks, shelves, etc., in their proper places. These are already packed to prevent any possible damage during shipping. 3.Leave your refrigerator on for 2 to 3 hours before storing food inside. Verify that there is a flow of cold air in the freezer compartment to ensure proper cooling. Your refrigerator is now ready for use. WARNING: • Take care when working with the hinges, base cover and stops, etc. You may injure yourself. • DO not place your hands or any tools in the air vents, the base cover or in the bottom of the refrigerator. This may cause injury or electrical shock. WARNING EXPLOSION HAZARD Keep a Proper Distance from Adjacent Objects Please keep the refrigerator at an adequate distance from other objects. Insufficient spacing can reduce the refrigerator's freezing efficiency and increase electricity consumption. Keep all flammable materials and vapors (such as gasoline) away from the refrigerator. Not following these instructions may cause death, explosion or fire CAUTION: This appliance is intended to be used in household and similar applications such as: staff kitchen areas in shops, offices and other working environments; farm houses and by clients in hotels, motels and other residential type environments, bed and breakfast type environments, catering and similar non-retail applications. 2" (5.08 cm) 2" (5.08 cm) 2" (5.08 cm) 2" (5.08 cm) 5