LG RU-27FB30C Operation Guide - Page 10

Hook Up An Over-The-Air Antenna Connect an off-air antenna. 1 Locate the Antenna/Cable jack on the back of the TV. Connect the antenna that runs from 2 the wall directly to this jack, according to one of the connection diagrams shown to the right. Remove the back of the remote 3 and put in two AA batteries. Antenna Flat wire (300 ohm) Back of the Remote Plug in your TV. This TV is 4 designed to operate on standard current, 120-volt 60 Hertz AC. Do not attempt to operate it on DC Current. 120 Volt 60 Hz AC If you have a 75 ohm RF cable, then you don't need any adapters! A 300 to 75 ohm adapter is not included with the LG TV. 300/75 ohm Adapter Typical TV Back Matrix Out Antenna Cable Component Video Input Pr Pb R Audio L Y Video In R Audio In L M.P.I. S-Video In R Audio In L Typical TV Back Matrix Out Antenna Cable Component Video Input Pr Pb R Audio L Y Video In R Audio In L M.P.I. S-Video In R Audio In L Mini Glossary 75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the back of the TV. 300 TO 75 OHM ADAPTER A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end. Page 10