LG WM1455HVA Owners Manual - Page 15

us_main.book.book Page 15 Friday, March 6, 2020 10:25 AM ENGLISH 4 Tighten the locknuts b • Turn the locknuts counterclockwise and tighten them when the washer is level. Using Non-Skid Pads If you install the washer on a slippery surface, it may move because of excessive vibration. Incorrect leveling may cause malfunction through noise and vibration. If this occurs, install the non skid pads under the leveling feet and adjust the level. 1 Clean the floor to attach the non-skid pads. • Use a dry rag to remove and clean foreign objects or moisture. If moisture remains, the non-skid pads may slip. 2 Adjust the level after placing the washer in the installation area. 3 Place the adhesive side of the non-skid pad on the floor. • It is most effective to install the non-skid pads under the front leveling feet. If it is hard to place the pads under the front leveling feet, place them under the back leveling feet. 4 Recheck the washer's levelness. • Push or rock the top edges of the washer gently to make sure the washer does not rock. If the washer rocks, level the washer again. Final Installation Check Connecting to the Power Supply Plug the washer into a 120 VAC, 60 Hz grounded 3prong outlet. INSTALLATION 15 WARNING • Do not use a worn or damaged power cord or power plug. Replace or repair it immediately. Failure to do so may result in death, fire, electric shock, or malfunction. • Do not modify the power cord and plug provided with the appliance. Do not damage it when installing or moving the appliance. Doing so may result in death, fire, electric shock, or malfunction. • Make sure that the appliance is grounded. • Connect this appliance to a grounded outlet conforming to the rating prior to use. Failure to do so may result in fire, electric shock, or malfunction. • Do not damage or cut off the ground prong of the power cord. Doing so may cause death, fire, electric shock, or product malfunction. • Improper connection of the equipment grounding conductor can result in risk of electric shock. Check with a qualified electrician or service technician if you are in doubt as to whether the appliance is properly grounded. If the plug does not fit the outlet, have a proper outlet installed by a qualified electrician. • The appliance and outlet must be positioned so that the plug is easily accessible. • Do not use an adapter or extension cord. Doing so may result in serious injury, fire, electric shock, or death. • For best performance, plug the appliance into its own individual outlet. This helps prevent overloading house wiring circuits which could cause a fire hazard from overheated wires. • If necessary, use a new, UL-listed 3-prong (grounding) plug rated at no less than the branch circuit. Do not use an extension cord longer than 3 feet. Failure to follow these warnings may result in serious injury, fire, electric shock, or death. Testing the Washer Check if the washer is properly installed and run a test cycle. 1 Load the washer with 6 thick bath towels (approximately 6 pounds). 2 Press the Power button.